HP SAS Hard Drives DELL SAS Hard Drives servers Hard Drives u320 Hard Drives SAS/SATA Hard Drives Memory Controllers Processors Power Supplies  Create Account    Your Cart    Checkout    Contact Us   
  Home : 504015-003 Login | Create Account | Your Cart | Checkout | Contact Us  


 Search By:   |    |     |  
ServersProliant Servers U320 DrivesProliant U320 Options SAS DrivesProliant SAS/SATA Options SATA DrivesProliant SAS/SATA Options Fibre DrivesProliant SAS/SATA Options MemoryProliant Memory Options ControllersProliant Controllers ProcessorsProliant Processors Power SuppliesProliant Power Supplies NetworkingNetwork Adapters
  Proliant SAS HotPlug Hard Drive Replacement Video. (Part# 504015-003)

FRU remove/replace: Hard Disk Drive Part# 504015-003


 

504015-003 Proliant Hard Disk Drive removal

Caution!  When replacing a hot-pluggable drive, follow these guidelines to prevent data loss:

  • Never remove more than one drive at a time (two drives if you are using Advanced Data Guarding).
  • Never remove a drive while another drive is being rebuilt.
  • If the system has an online spare drive, wait for it to complete rebuilding before replacing the failed drive.
  • If you replace a drive while the system is off, it may be necessary to rebuild the replaced drive.

Caution!  Removing more than one drive at a time can cause the enclosure to overheat. Install a drive or drive blank as soon as possible.

  1. Press the thumb latch and pull the ejector lever to the full open position.
  2. Pull the drive out of the enclosure drive bay.
  3. If installing a hard drive blank in place of the drive, insert the blank into the bay until it clicks into place.

504015-003 Proliant Hard Disk Drive replacement

  1. If a drive blank must be removed to install a new drive, squeeze the tabs to unlock the drive blank. Continue to squeeze the tabs while sliding the drive blank out of the drive bay.
  2. When installing a replacement drive, press the thumb latch and pull the ejector lever to the full open position.
  3. Insert the drive into the bay, sliding it in completely. Make sure the ejector lever is in the full open position to ensure a correct latch.
  4. Close the ejector lever against the front of the drive until it clicks into the thumb latch.
  5. Confirm that the drive is firmly seated and that the ejector lever is latched.
  6. Caution!  Data can be lost if the drive is not firmly seated.

  7. Observe the drive status LEDs to confirm that the replacement drive is functioning properly.
HardDrivesDirect          Ph: 1-613-599-1287                   Fax: 1-613-599-8120
Home | Shopping Cart | Delivery | Forgot Password | Order By Phone | Create an Account | Add to favorites
   
Legal |Privacy | | Primary Site |Contact us | Site Problem?  |  Controllers
 Controllers  Drives  processors  memory  tapedrives